Snow Joe Pressure Joe SPX3000 Betreibershandbuch PDF herunterladen (Seite 8)

13. Attach garden hose to water supply (Fig. 17).

mWARNING! The intake water temperature must not

exceed 104ºF/40ºC. The water supply must not exceed

0.7 MPa.

mCAUTION! The washer must only be used with clean

water; use of unltered water containing corrosive chemicals

will damage the washer.

14. Push the motor switch to the OFF (0) position (Fig. 18).

15. Check that the electrical supply voltage and frequency

(Volt/Hz) correspond to those specied on the washer

rating plate. If the power supply is correct, you may now

plug the washer into the power outlet (Fig. 19).

Operation

IMPORTANT! This pressure washer is equipped with

a micro-switch sensitive to water ow. This Total Stop System

(TSS) senses water ow in the pump. When the trigger is

released, water stops owing through the pump. The TSS then

automatically turns the motor off to protect the pump from

overheating.

1. Turn the water supply tap on completely.

2. Push the safety lock down and into its original position

(Fig. 20), then press the trigger for a few seconds

until water ow is steady to allow air to escape and to

discharge residual pressure in the hose.

Fig. 16

Water inlet

(female coupler)

(FRONT)

Garden hose

This end to

water inlet

Garden hose

(male end)

Fig. 17

Connect to water supply

Garden hose

OFF

Fig. 18

Fig. 19

(GFCI)

Fig. 20

Safety lock

Slot

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Snow Joe Pressure Joe SPX3000 Betreibershandbuch Seite 8